(+372) 38 46320 sales@brandner.ee
Tööstuse 17, 72720 Paide Estonia

Blind milling / Z-milling

Blind milling on a printed circuit board design is used for several reasons.
For example:
1. To be able to create component openings or cut outs.
2. Plated blind milling is used for heat removal.
3. To be able to fix the special profiles.

In case of the blind milling the parameters of the usual mill are applicable.
Minimum milling tool available for blind milling in Brandner is 0,6mm and the maximum tool is 2,5mm.
Depth tolerance of blind milling is +/- 7um

By continuing to use the site, you agree to the use of cookies. more information

The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.